top of page
Through-the-Wall Air Conditioner Covers That Actually Fit
Why Cover a Through-the-Wall AC Unit in Winter?
An uncovered wall air conditioner is an open hole in your building. Cold air pours in through
the sleeve; the unit collects rain, snow, dirt, and insects, and by spring you have corrosion
and a shorter service life. A properly fitted cover stops the draft, protects the unit, and gives the building a clean, uniform look instead of a patchwork of plastic and duct tape.
Built for Apartment Buildings, Condos, Hotels, and Homeowners
Property managers order BreezeBlocker covers by the case because every unit ends up looking the same, and residents can't damage trim or drywall installing them. Homeowners order one or two because it takes a minute and lasts for years. Volume pricing starts at 25 units.
Not Sure What Size You Need?
Measure the outside dimensions of your sleeve — width and height — and match them to our size chart. We stock five standard outdoor sizes and six indoor sizes that fit most Westinghouse, GE, Hotpoint, Whirlpool, Frigidaire, Kenmore, Norge, Fedders, Coldpoint, and Friedrich units. If your unit isn't standard, we manufacture custom sizes. Call 847-731-3597 and we'll size it with you.
Reusable, Not Disposable
A BreezeBlocker cover comes off in spring, folds up, and goes back on the following fall — year after year. Compare that to plastic sheeting you buy, tape on, tear off, and throw away every single season.
BreezeBlocker makes fleece-lined vinyl covers built specifically for through-the-wall and PTAC air conditioners. They slip over the sleeve in under a minute, stay put with an internal shock cord, and block the winter drafts that drive up your heating bill — without tape, screws, bungee cords, or a garbage bag flapping off the side of your building. Proudly made in the USA.
bottom of page